Squeeze action bottle pumps solution to a storage case for easy contact lens care.
Salt Lake City, UT -- (SBWIRE) -- 11/01/2013 -- Contacts2Go will be manufactured using a range of plastic injection molding techniques, as well as a variety of materials such as PP (Polypropylene) and rubberized plastic, all approved by the FDA for medical devises and are non toxic and non permeable, to prevent bacterial buildup.
When the successful funding of the Contacts2go is complete, the expert engineers at “Sun Tooling and manufacturing” located in Centerville Utah will ensure the tightest tolerances possible to make sure the C2G meets the highest possible standards.
When the tooling is complete and the first samples are assembled, the team will test and approve the first run and post an update to all funders. It will take approximately another 3 weeks to produce package and ship the first run. So funder's can expect them around January 2014.
This campaign will receive all funds raised even if it does not reach its goal. Funding duration: October 16, 2013 - December 03, 2013 (11:59pm PT).
Funding support will go directly towards the tooling and manufacturing of the Contacts2go components , engineered and produced by "Sun tooling" of Salt lake city, Utah .
Campaign information can be found at: Indiegogo Page: http://bit.ly/18suDiu
Copyright © 2005-2013 - SBWire, The Small Business Newswire - All Rights Reserved - Important Disclaimer
Contact Us: 888-4-SBWIRE (US) - 920-593-5640 (International)