Jamnagar, Gujarat -- (SBWIRE) -- 01/29/2012 -- Jamnagar based manufacturer Brass pipe Fittings India launches a new range of flexible entry boots and pipe fittings for composite hoses.
Brass Pipe Fittings is a Jamnagar India based manufacturer and exporter of Brass pipe fittings Brass plumbing fittings hose couplings etc.They have recently launched a new range of flexible entry boots and fittings for composite hoses for the European marketl.
Brass Pipe Fittings made Flexible Entry Boots are reliable, safe seals for pipe and conduit entries into underground containment sumps.
These entry boots allow for angled pipe entries and have no exposed metal parts to the underground environment.These entry boots are available in a variety of sizes and designs to accommodate rigid and flexible piping, ducting and access pipe.
Angled Entries:
Primary pipe and access pipe entering the containment sumps may not be perpendicular with the sump wall. Angled entries are generally a result of directional plumbing restrictions on the inside of the containment chamber due to space limitations. Flexible entry boots are flexible enough to permit angled pipe or conduit entries (on two axes) into the sidewall of a containment chamber. All flexible entry boots permit angled entries up to a 15-degree angle off the perpendicular center line in any direction without leaking or putting undue stress on the pipe or conduit seal.
Specifications:
Specifications for Single Flexible Entry Boot and Fitting
STF -0751 1/2", 3/4" and 1" Conduit Entry Boot Fitting 2-3/8" 6.03
STF-0150 1.5" Entry Boot Fitting for 1.5" DW FlexWorks Pipe 3-3/4" 9.52
STF-0200 2" Entry Boot Fitting for 2" DW FlexWorks Pipe or 2" LCX 3-3/4" 9.52
STFF-0200F 2" Entry Boot Fitting for 2" Rigid Pipe 3-3/4" 9.52
STFF-0300 3" Entry Boot Fitting for 3" DW FlexWorks Pipe or
3" Rigid Pipe/LCX 5" 12.7
STF-0400 4" Entry Boot Fitting for 4" Rigid Pipe/AXP Pipe 5-1/2" 13.97
STF-0600 6" Entry Boot Fitting for 6" Rigid Pipe Saber Saw
STF -7400 4" Sump Access Boot 5" 12.7
Sump Entry:
Flexible entry boots have been tested to withstand a minimum of 6' of liquid head pressure. These seals provide a studded flange connection to create a positive and secure seal where the rubber contacts the sump wall and also around the pipe or conduit. Tightening down on a series of stud fasteners with a compression ring provides a high compression mechanical seal compared to screw on type bulkhead seals.
Apart from above mentioned products Brass pipe fittings also offers Brass hose barbs, Brass tank connectors, Brass anchors,Brass fasteners, Brass inserts, Brozne fittings etc.
You may visit their site at http://www.brass-pipe-fittings.com and for products http://www.brass-pipe-fittings.com/products.html and http://www.brass-pipe-fittings.com/resources.html for more details.